|
Wings 3D sorozat - középhaladó |
|
|
|
|
Írta: Administrator
|
|
2006. február 19. vasárnap 22:09 |
|
Wings 3D minisorozatunk második részében a következő fogásokról lesz szó: - Extrude (kihúzás)
- Extrude Region (terület kihúzása)
- Scale (átméretezés)
- Multiple Undo (összetett visszavonás)
- Flatten (lapítás)
- Cut (vágás)
Step 01 Select the two polygons. Select extrude, then normal. 
Step 02 Move the faces until it reaches a desired point. 
Step 03 Scale faces. 
Step 04 Undo multiple recent actions by pressing Ctrl+Alt+Z until all signs of extruding are gone. Select the two polygons again. Select extrude region, then normal. Notice the two polygons are not separate. 
Step 05 Select the bottom faces. Select extrude region, then normal. Now select previously extruded faces. 
Step 06 Select scale, then uniform. 
Step 07 Select faces. 
Step 08 Select flatten, then X. 
Step 09 Notice the faces are now parallel to the Z axis and the faces are perpendicular to the X axis. 
Step 10 Leave the faces selected. Press E to select edges. 
Step 11 Notice the edges of the faces are automatically selected. 
Step 12 Right Click and select cut. 
Step 13 Then select 2. 
Step 14 Each edge has been cut into two edges. The new vertices created are automatically selected. 
Step 15 Move upper vertices Y. Then move corresponding lower vertices on the Y axis. 
Step 16 Select vertices. Scale uniform. The use of scale in this way can save much time! 
Step 17 Do the same for the other side. The results should look similar. 
|
|
Utolsó frissités ( 2006. február 19. vasárnap 22:17 )
|